Couplings: When Rigid Is Right and When It Destroys the Bearing
The purpose of a flexible coupling is not to allow sloppy alignment. It is to absorb the small residual misalignment and the thermal movement that exists even in a properly aligned machine, so that the bearings do not have to.
A rigid coupling — a sleeve or a clamp — transmits torque with zero backlash and no wind-up. It is the right choice when the two shafts are effectively one shaft: a gearbox output driving a pump through a rigidly mounted bearing housing, with both components on a common machined base. It is the wrong choice when either component can move even slightly.
If a rigid coupling is used with misalignment, the symptom is not a coupling failure. The coupling is far stronger than the bearing. The symptom is premature bearing failure on the adjacent shaft, often accompanied by seal wear, and it usually gets diagnosed as a bearing quality problem.
Jaw couplings (spider couplings) are the general-purpose compromise: two hubs with an elastomer spider between them. They handle angular and parallel misalignment, damp vibration, and are cheap. The spider is the wear part — replacing it is a maintenance item, not a rebuild.
Bellows and disc couplings handle higher speeds and temperatures with no backlash and no elastomer to degrade. They cost more and tolerate less misalignment, but they are the right choice for servo axes and high-precision positioning.
The selection order: torque and speed first to size the coupling, then misalignment tolerance to pick the type, then torsional stiffness if the application is servo-driven. Selecting on bore size alone is how couplings get undersized — a coupling can fit the shaft and still fail in torsion.
One practical note: always check the bore range before committing. Many couplings are supplied with a pilot bore and machined to order, which adds lead time and means the bore is a specification, not a stock item.