Fastener Grades: When A2-70 Is Enough and When You Need 12.9
Fasteners are the category most often ordered by dimension alone: M8x30 is M8x30, so the cheapest quote wins. Dimension only decides whether it fits. Grade decides whether it holds.
The three grades you will meet most: A2-70 (austenitic stainless, roughly 700 MPa tensile), 8.8 (quenched and tempered carbon steel, roughly 800 MPa), and 12.9 (alloy steel, roughly 1220 MPa). They are not interchangeable at the same size.
A2-70 is the right choice when corrosion matters more than clamp load: outdoor equipment, washdown areas, food processing, anything seeing mild acids. Its weakness is that stainless galling makes it easy to over-torque and shear, and its preload ceiling is lower.
8.8 is the general-purpose structural grade. If a drawing says "bolt" with no grade, 8.8 is usually what was meant.
12.9 is for high preload: mould clamping, machine tool structures, press frames. Use it where the joint must stay tight under vibration and cyclic load. The trade-off is hydrogen embrittlement risk if the plating process is not controlled, and it needs a proper torque spec — hand-tight plus a bit will not develop the clamp load you paid for.
The practical rule: calculate the required clamp load first, then pick the lowest grade that achieves it with margin. Upgrading "just to be safe" without checking the mating thread strength moves the failure from the bolt to the tapped hole, which is far more expensive to repair.
One more thing worth checking: mixing grades on the same joint. A 12.9 bolt into an aluminium casting will pull the thread out of the casting long before the bolt yields. The weak link is whichever side is softer.