Linear Bearing or Guide Block? The Choice Depends on Moment Load
Both carry a load along an axis. The difference is what they do with everything else.
A linear bearing (LM series) runs on a hardened shaft and carries load in all radial directions, but its moment capacity is poor. Put one bearing on a shaft with an overhung load and it will rock. Two bearings spaced apart solve this, which is why linear bearing applications almost always use a pair per shaft.
A guide block (HGH series) runs on a profiled rail with four-point contact. It carries moment load far better per block, which is why machine tools use one or two blocks per rail and get away with it.
Stiffness is the second difference. A guide block with light preload is significantly stiffer than a linear bearing in the same envelope, because the rail and block are matched as a set. If you are chasing chatter or deflection, this matters more than nominal load rating.
Accuracy is the third. Rail straightness and block-to-rail clearance are controlled at manufacture for a guide system. A shaft and a bearing are separate parts with separate tolerances, and the stack-up shows up as runout.
Cost is where the linear bearing wins decisively — often a third of the price for the same load. So the decision rule is: if the load is purely radial and you can space two bearings apart, use linear bearings. If there is meaningful moment load, or you need stiffness and accuracy for machining, use a guide block.
The failure mode differs too. Linear bearings fail by brinelling the shaft raceway after contamination gets past the seal — a shaft replacement, not just a bearing swap. Guide blocks fail by losing preload or wearing the ball retainer, and only the block needs replacing. That maintenance cost difference is worth including in the comparison.