Linear Guide Selection: Load Rating, Preload and Accuracy Grade
When engineers specify a linear guide, they usually start from the rail width. That is the right first step and the wrong last one. Width tells you what fits the mounting surface. It tells you nothing about whether the block will survive the load.
Work out the dynamic load rating first. This is the load at which the bearing reaches a nominal travel life, typically 50 km or 100 km depending on the standard the manufacturer quotes. If your calculated load is 40 percent of the dynamic rating, life drops to roughly a fifteenth of nominal — which is how a guide that was "rated for it" fails in eight months instead of five years.
Account for the load direction. Most blocks are rated differently for downward, upward, side and moment loads. A single block carrying an overhung load is a moment load, not a downward load, and the effective rating can be far lower than the headline number. Two blocks on one rail share the moment; one block does not.
Preload is the next decision. Zero clearance is fine for light, smooth motion. Light preload (often designated Z1 or similar) removes play and is the normal choice for machine tools. Heavy preload stiffens the axis at the cost of friction and heat. Over-preloading a guide to fix a rigidity problem elsewhere in the structure is a common and expensive mistake.
Accuracy grade decides how straight the rail is and how much the block will deviate over its travel. Normal grade is adequate for transport and pick-and-place. High grade is needed for machining. Precision grade is for metrology and grinding. Upgrading accuracy is cheap compared with scrapping parts because the axis wandered.
The catalogue numbers on this site are organised by exactly these dimensions so you can filter to the right class before you look at price. If you are sizing a new axis, send the load case and we will run the life calculation with you.