Packaging Industrial Goods So They Arrive Undamaged
Freight damage claims are slow and rarely recover the full cost. Preventing the damage is cheaper, and it starts with knowing how each product class fails.
Bearings fail by brinelling — the raceways dent when the assembly takes a shock load, and a dented raceway is a noisy, short-lived bearing. The fix is immobilising the bearing so it cannot transmit shock: individual boxes with internal support, no loose bearings rattling against each other, and no dropping onto a hard surface during handling.
Linear rails and shafts fail by bending. A one-metre rail supported only at the ends will sag and take a permanent set under its own weight plus handling. Support at 400-500 mm intervals, or ship in a rigid tube with end caps.
Electronics fail by electrostatic discharge and by connector damage. Conductive bags, foam that does not shed, and connectors protected from side load. Desiccant where humidity swings are large — condensation on a cold metal chassis in a warm warehouse is a real failure mode.
Fasteners are the easiest and most often done badly. Bulk bags of screws arrive with damaged threads from mutual abrasion. Boxed, with a liner, is only slightly more expensive and eliminates the problem.
The structural rule that covers most of it: the product should not be able to move inside its inner packaging, and the inner packaging should not be able to move inside the outer carton. Two levels of immobilisation, then the pallet.
Pallet configuration matters more than people expect. Overhang invites crush damage at the corners; underhang invites the load above to collapse into it. Stack height should be limited to what the bottom carton can bear — which is almost never what the sales team wants to ship.