How to Specify a Deep Groove Ball Bearing Without Getting It Wrong
Most bearing returns we see are not manufacturing defects. They are specification errors: a part that fits the shaft but not the housing, or one that fits both and still fails because the seal type let coolant in.
Start with the four dimensional numbers. Bore diameter, outer diameter, width, and the chamfer minimum. A 6204 and a 6205 differ by five millimetres of bore, which sounds trivial until the shaft is already machined. Always specify from the drawing, not from the part number you used last time on a different machine.
Then decide the seal. The 2RS suffix means double rubber seal, and the ZZ suffix means double metal shield. Rubber seals keep coolant and fine dust out and are the right default for wet or dusty environments, but they add friction and cap the speed. Metal shields run cooler and faster but let fine particles through. If the application is a high-speed spindle, shielded is usually correct; if it is a conveyor in a washdown area, sealed is.
Clearance is the next thing people skip. Standard clearance (CN) covers most applications. If the bearing runs hot — either from speed or from a press fit that closes up the internal clearance — you need C3 or C4. Specifying CN on a hot-running application is one of the most common causes of premature failure, and it will not show up until the bearing has been running for weeks.
Finally, check the speed rating against your actual operating speed, not the motor nameplate. A 14000 rpm limit sounds generous until you account for grease life at that speed, which is measured in hundreds of hours, not years.
If you are unsure, send us the application — shaft size, load direction, environment and running speed. We will come back with two or three options at different price points and tell you which one we would put in our own line.